Saturday, August 24, 2013

RC4WD Trail Finder 2 Build

I did a lot more cutting!
Both doors are off...
...I cut the front grille, I do have to finish sanding the lower half of the grille...

... and I bobbed the bed. (Or if you are not familiar with the term, I shortened the bed.) Bobbing the bed gives the truck a better departure angle.
I didn't cut as much off of this bed as I would have liked too because I wanted the bed to line up with the frame rails, but it's better than the bed in stock form.
Next, I will add the full back to the cab, cut out the grille, putty what's left of the mounting holes on the body, and then begin the interior!
Thanks for following!

No comments:

Post a Comment